The following is an overview and setup video of the CSM ThrottleSafe.

This is a safety device which sits between the rx and the servo. On detecting various conditions it will cut the engine. These conditions include total power failure, signal loss and low voltage conditions. The idea being that in these scenarios your heli doesn't fly off powered and out of control or crash and do the chicken dance.

( 6 Votes )

The following is a video of how to setup the CSM Revlock governor on a nitro helicopter.

The video covers installation of magnet and sensor right through to configuring the governor and your tx.

( 6 Votes )

The following video explains how to navigate the DX7 system menu.

The video covers models selection, model memory copying, throttle recovery function, input selection, memory reset, integral timer reset, sawshplate selection and chossing heilcopter or acro mode.

( 34 Votes )

The following video explains how to set up the Align GP750 gyro from a programming the gyro perspective.

( 46 Votes )